Configuring Frame-Relay, Part 2
Written by jlgaddis on May 30, 2009 – 2:51 pm -In “Configuring Frame-Relay, Part 1″, I demonstrated how to configure a basic frame-relay hub and spoke network.
In Part 2, we have the same three routers with the same physical topology, but we’ll be using point-to-point connections between each of the routers.
Here’s the topology…
…and the walkthrough…
In Part 3, we’ll add another router, R4, to the topology and use a combination of the physical interface and point-to-point subinterface on R1 to demonstrate how to use both simultaneously. We’ll follow that up in Part 4 by adding OSPF to the whole network to show the differences over various types of networks.
Tags: ccna, cisco, labs, networking, video | 4 Comments »
June 4th, 2009 at 1:47 am
I believe the wrong video is embedded (Part 1 instead of Part 2)
June 4th, 2009 at 10:46 am
@George:
You’re right. Sorry about that, I’ve fixed it to show the right video now. Thanks!
July 7th, 2009 at 4:20 pm
[...] series. In part 3, we’ll combine what we’ve learned from part one and part two and work with this [...]
July 8th, 2009 at 8:33 am
[...] frame-relay. If you haven’t been following along, you may want to check out part one, part two, and part three before [...]